Two technicians are discussing cooling system hose replacement. Tech A says to make sure that the hose clamps
get installed just inside the flared or barbed segment of the
fitting, not on top of it. Tech B says that it is good practice
to install new hose clamps at the same time as new hoses.
Who is correct?
a. Tech A
b. Tech B
c. Both A and B
d. Neither A nor B

Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise