Engineering, 03.03.2021 18:10 lilinicholeb
While having a discussion about chuck, Technician A says that chuck runout is allowed to be up to 0.010" in
a consumer drill. Technician B says that it is allowed to be 0.005 in a commercial drill. Who is correct?
a. A only
c. Both A and B
b. Bonly
d. Neither A nor B
Answers: 2
Another question on Engineering
Engineering, 03.07.2019 14:10
When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point
Answers: 3
Engineering, 04.07.2019 18:10
Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.
Answers: 3
Engineering, 04.07.2019 18:10
During a steady flow process, the change of energy with respect to time is zero. a)- true b)- false
Answers: 2
Engineering, 04.07.2019 18:10
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
You know the right answer?
While having a discussion about chuck, Technician A says that chuck runout is allowed to be up to 0....
Questions
History, 03.11.2019 04:31
Mathematics, 03.11.2019 04:31
English, 03.11.2019 04:31
Health, 03.11.2019 04:31
Mathematics, 03.11.2019 04:31
Social Studies, 03.11.2019 04:31
Advanced Placement (AP), 03.11.2019 04:31
Computers and Technology, 03.11.2019 04:31
