Engineering, 05.03.2021 06:20 polarbear3787

Styles 6. Match the maintenance requirement to the correct tool in the table below.
There may be more than one correct answer.
Place letter in the column below.
A. Pedestal grinder B
Wipe with a clean cloth and remove dirt and dust
from air vents.
B. Pistol drill
Blades should be replaced when required.
C. Jigsaw
Battery packs should be recharged
D. Portable Sander
Mechanical parts should be lubricated regularly
E. Chainsaw
Dress wheels regularly. Do frequent, light dressings
rather than one heavy dressings.
7. In your words describe the procedure you would follow to correctly position a drill bit when
sharpening it on a bench grinder.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

The mass flow rate of the fluid remains constant in all steady flow process. a)- true b)- false

Answers: 1

Answer

Engineering, 04.07.2019 19:20

The power source in a certain welding setup generates 3500w that is transferred to the low carbon steel work with a heat transfer factor of 0.85. the melting factor in the operation is 0.45. a continuous fillet weld is to be made with a cross-sectional area of 23 mm2 determine the travel speed at which the welding can be accomplished.

Answers: 3

Answer

Engineering, 04.07.2019 19:20

Air enters a horizontal, constant-diameter heating duct operating at steady state at 290 k, 1 bar, with a volumetric flow rate of 0.25 m°/s, and exits at 325 k, 0.95 bar. the flow area is 0.04 m2. assuming the ideal gas model with k = 1.4 for the air, determine (a) the velocity at the inlet and exit, each in m/s, and (c) the rate of heat transfer, in kw flow rate, in kg/s, (b) the mass kg 0.3

Answers: 2

Answer

Engineering, 06.07.2019 02:30

On solidification from a melt, the polymer polyethylene forms a semi-crystalline spherulite structure. (i) sketch an individual spherulite and label the amorphous and crystalline regions. (ii) draw a schematic to show the changes in specific volume with temperature during cooling from the melt, comparing it to the theoretical extremes of fully crystalline and fully amorphous (indicate tm and tg)

Answers: 2

Answer

You know the right answer?

Styles 6. Match the maintenance requirement to the correct tool in the table below.
There may...

Questions