Engineering, 17.03.2021 23:40 aspenwheeler6804
B. Given the following data for a laboratory measurement of relative permeability ratio:
qg, Cmº/sec
Run
qw, Cm/sec
1
30.21
0
2
27.99
0.66
3
12.41
0.186
4
6.01
0.522
5
0
1.985
it A -5.2 cm, L = 4.4 cm, Hy = 0.018 cp, Hw = 1 cp
Wt of dry sample=25 gms
Wt of sample 100% saturated with water = 35 gms
Sw, %
10
40
60
80
90
Plot: Kg/K. vs. Sw on a semi-log paper.
Calculate: constants (a) and (b) for the following correlation K,/Ky = a e-b Sw.
Answers: 1
Another question on Engineering
Engineering, 03.07.2019 15:10
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:20
Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent
Answers: 2
Engineering, 04.07.2019 18:20
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
You know the right answer?
B. Given the following data for a laboratory measurement of relative permeability ratio:
qg, Cmº/se...
Questions
History, 26.01.2020 07:31
Business, 26.01.2020 07:31
Mathematics, 26.01.2020 07:31
Mathematics, 26.01.2020 07:31
Mathematics, 26.01.2020 07:31
Mathematics, 26.01.2020 07:31
Social Studies, 26.01.2020 07:31
Mathematics, 26.01.2020 07:31
Biology, 26.01.2020 07:31
Mathematics, 26.01.2020 07:31
