Engineering, 18.03.2021 01:40 trint4

1. Draw from memory a detail of a typical slab on grade and list the steps in its production. Why can't the surface be finished in one operation, instead of waiting for hours before final finishing?2. What are control joints and isolation joints? Explain the purpose and typical locations for each in a concrete slab.3. List the steps that are followed in forming and pouring a concrete wall.4. Distinguish one-way concrete framing systems from two-way systems. Are steel and wood framing systems one-way or two-way? Is one-way construction more efficientstructurally than two-way construction?5. List the common one-way and two-way concrete framing systems and indicate the possibilities and limitations of each.6. Why posttension a concrete structure rather than merely reinforce it?

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Items are similar to the free issue items, but their access is limited. (clo5) a)-bin stock items free issue b)-bin stock controlled issue c)-critical or insurance spares d)-rebuildable spares e)-consumables

Answers: 1

Answer

Engineering, 04.07.2019 18:20

An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.

Answers: 3

Answer

Engineering, 04.07.2019 19:10

What are the major differences between injection molding and extrusion?

Answers: 2

Answer

You know the right answer?

1. Draw from memory a detail of a typical slab on grade and list the steps in its production. Why ca...

Questions