subject
Engineering, 19.03.2021 01:30 bryn2433

Air enters the compressor of a gas turbine at 100 kPa, 300K, and a volumetric flow rate of 5 m3 /s. The air is compressed in two stages to 1500 kPa, with intercooling to 300 K between the stages at a pressure of 400 kPa. The turbine inlet temperature is 1400 K and the expansion occurs in two stages, with reheat to 1300 K between the stages at a pressure of 400 kPa. The compressor and turbine stage efficiencies are both 90%. Determine:

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
question
Engineering, 04.07.2019 18:10
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
question
Engineering, 04.07.2019 18:10
The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m
Answers: 2
question
Engineering, 04.07.2019 19:10
An engine, weighing 3000 n, is supported on a pedestal mount. it has been observed that the engine induces vibration into the surrounding area through its pedestal at the maximum operating speed. determine the stiffness of the dynamic vibration absorber spring in (n/m) that will reduce the vibration when mounted on the pedestal. the magnitude of the exciting force is 250 n, and the amplitude of motion of the auxiliary mass is to be limited to 2 mm note: in this question type-in right numbers, no decimals, no fractions, no unit. approximate to right number if needed
Answers: 3
You know the right answer?
Air enters the compressor of a gas turbine at 100 kPa, 300K, and a volumetric flow rate of 5 m3 /s....
Questions
question
Health, 03.12.2020 23:10
question
History, 03.12.2020 23:10
question
Chemistry, 03.12.2020 23:10
question
Mathematics, 03.12.2020 23:10
question
Biology, 03.12.2020 23:10
Questions on the website: 13722360