Engineering, 19.03.2021 16:10 ttaysia

Consider two possible schemes for measuring angular velocity with an encoder. In Scheme A, a timer is set for a specified time interval TA, and the number of W/B transitions, MA, occurring in that interval are counted. In Scheme B, the time, TB, required for a fixed number MB of W/B transitions is measured. Which of the following statements is true? 1. In scheme A, time interval TA is not the exact time that has elapsed for MA W/B transitions.
2. In scheme A, time interval TA is the exact time that has elapsed for MA W/B transitions.
3. Scheme A and scheme B, both have the same level of accuracy.
4. Scheme A is better than scheme B.
5. Scheme A is equivalent to scheme B.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:20

Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?

Answers: 2

Answer

Engineering, 04.07.2019 19:20

Afan that can provide air speeds up to 60 m/s is to be used in a low-speed wind tunnel with atmospheric air at 35 c. if one wishes to use the wind tunnel to study flat-plate boundary layer behavior up to reynolds numbes of re 10, what is the minimum plate length that should be used? at what distance from the leading edge would transition occur if the critical reynolds nurnber were rer,e = 5 × 105?

Answers: 2

Answer

Engineering, 06.07.2019 02:30

Precipitation hardening can be achieved in many light alloys by a three-step heat treatment. what is carried out and what is the purpose at each step? why is such a treatment necessary based on the nucleation and growth theory of phase transformation. compare this treatment with tempering martensite for carbon steels (similarities and differences).

Answers: 1

Answer

Engineering, 06.07.2019 05:10

Explain linear and angular momentum analysis for flow systems.

Answers: 2

Answer

You know the right answer?

Consider two possible schemes for measuring angular velocity with an encoder. In Scheme A, a timer i...

Questions