Engineering, 21.03.2021 23:50 iiisavageoreo

Q2: Use navigation sensors to track an AUV with acoustic transceivers and DVL Q2.1. We have two acoustic hydrophones to detect the sound transmitted from the AUV. As shown in the figure below, the range to the AUV measured by the #1 hydrophone is 200m and by #2 hydrophone is 215m, and the baseline, b, is 20 meters. What is the vertical and horizontal distance between the AUV and hydrophone #1? [10pts]. The equation that will be used is in Topic-4 presentation. (show full calculation steps)

Q2.2. The AUV is equipped with a DVL that transmits sound at 1MHz. The beam angle is 22.5 degrees. The AUV is moving at a speed, u, of 2 m/s. As presented in the lecture, we can separate it into two components, one along the sound transmission of #1 beam on the DVL, one is perpendicular to the sound transmission. Question: now let’s separate u relative to beam #2, draw the two components in the figure and compute the magnitude of the two components. [5pts]

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Ifa component is made of two or more materials with different modulus of elasticity (e), it is called a composite member and we calculate the factor·n". mention the formula for calculating n". also, ifn> 1, explain what will happen to the 1. transformed.gi) ifn 1, what will happen to the material when transformed material when

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?

Answers: 3

Answer

Engineering, 04.07.2019 19:10

In general, how do thermosetting plastics compare to thermoplastics in mechanical and physical properties?

Answers: 3

Answer

Engineering, 04.07.2019 19:10

Estimate the change in specific internal energy au and specific enthalpy h from inlet to outlet for ethylene glycol (a liquid) flowing through each of the following devices: (a) a heat exchanger where the glycol temperature increases from 20 °c to 80 °c; (b) a pump operating at about 25 °c and increasing the glycol pressure from 100 kpa to 8 mpa.

Answers: 2

Answer

You know the right answer?

Q2: Use navigation sensors to track an AUV with acoustic transceivers and DVL Q2.1. We have two aco...

Questions