Engineering, 23.03.2021 06:00 jwyapo4
A power winch is designed to raise a 4,961 N load 10 meter in 2 minutes. The winch is designed with a 283 mm diameter drum taking up the wire lifting the load. The drum will be connected to a 9 rpm motor through a gearbox. What is the minimum torque (Nm) that the motor shaft coupling should be designed to transmit
Answers: 1
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
Engineering, 04.07.2019 18:10
Afluid flows with a velocity field given by v=(x/t)i.. determine the local and convective accelerations when x=3 and t=1.
Answers: 2
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
Engineering, 04.07.2019 18:20
Apiston-cylinder device contains 0.1 m3 of liquid water and 0.9 m3 of water vapor in equilibrium at 800 kpa. heat is transferred at constant pressure until the temperature of water reaches 350 °c. determine (a) the quality of water at the initial state (b) the work associated with this process, (c) the heat associated with this process.
Answers: 2
A power winch is designed to raise a 4,961 N load 10 meter in 2 minutes. The winch is designed with...
Mathematics, 02.11.2020 14:00
Mathematics, 02.11.2020 14:00
History, 02.11.2020 14:00
Mathematics, 02.11.2020 14:00
English, 02.11.2020 14:00
English, 02.11.2020 14:00
Social Studies, 02.11.2020 14:00
Geography, 02.11.2020 14:00
English, 02.11.2020 14:00
Mathematics, 02.11.2020 14:00