Engineering, 24.03.2021 16:30 homeschool0123
A company has a stack that emits a hazardous air pollutant. The ground mass concentration directly downwind of the plume sometimes exceeds the safe limit (call it cj, safe) and the Department of Environmental Protection (DEP) is requiring a correction to this situation. The company decides to look into building a taller stack, rather than investing in a more sophisticated and very expensive APCS. They hire you as a consultant to calculate how tall the new stack would have to be in order to satisfy DEP.
Required:
a. Generate an equation to determine the stack height hs required such that, for the reflecting ground case, the ground level concentration on the ground directly downwind (y = 0 and z = 0) does not exceed the safe level at any location along the ground.
b. Repeat for the absorbing ground case.
c. Discuss. Is this a good solution for the company’s problem? For the environment?
Answers: 3
Another question on Engineering
Engineering, 03.07.2019 14:10
Amass of m 1.5 kg of steam is contained in a closed rigid container. initially the pressure and temperature of the steam are: p 1.5 mpa and t 240°c (superheated state), respectively. then the temperature drops to t2= 100°c as the result of heat transfer to the surroundings. determine: a) quality of the steam at the end of the process, b) heat transfer with the surroundings. for: p1.5 mpa and t 240°c: enthalpy of superheated vapour is 2900 kj/kg, specific volume of superheated vapour is 0. 1483 m/kg, while for t 100°c: enthalpy of saturated liquid water is 419kj/kg, specific volume of saturated liquid water is 0.001043m/kg, enthalpy of saturated vapour is 2676 kj/kg, specific volume of saturated vapour is 1.672 m/kg and pressure is 0.1 mpa.
Answers: 3
Engineering, 03.07.2019 14:10
The y form of iron is known as: a) ferrite b) cementite c) perlite d) austenite
Answers: 3
Engineering, 03.07.2019 14:10
Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned
Answers: 2
Engineering, 03.07.2019 19:30
When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line
Answers: 3
You know the right answer?
A company has a stack that emits a hazardous air pollutant. The ground mass concentration directly d...
Questions
Mathematics, 12.09.2019 01:30
Mathematics, 12.09.2019 01:30
Mathematics, 12.09.2019 01:30
Mathematics, 12.09.2019 01:30
