subject
Engineering, 25.03.2021 19:30 sclifton2014

A shaft and hole have a nominal diameter of 1 in. The shaft has a tolerance of 0.003in, the hole has a tolerance of 0.004in and the allowance is set at 0.001in. The dimensions are based on the Basic Hole System. Show the deviations for the shaft and the hole from nominal size; calculate the maximum and minimum clearance for two mating parts.

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:20
Derive the correction factor formula for conical nozzle i=-(1+ cosa) and calculate the nozzle angle correction factor for a nozzle whose divergence hal-fangle is 13 (hint: assume that all the mass flow originates at the apex of the cone.
Answers: 3
question
Engineering, 04.07.2019 18:20
Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency
Answers: 1
question
Engineering, 04.07.2019 18:20
For each of the following process: a) sketch the p-v diagram, b)sketch t-s diagram, c) sketch t-v diagram, d) sketch the boundary work on one of the diagrams (a, b or c) and e) sketch the reversible heat transfer on one of the diagrams (a, b or c): 1- isobaric process from compressed liquid to superheated vapor 2- isothermal process from compressed liquid to superheated vapor 3- isentropic process from compressed liquid to superheated vapor
Answers: 3
question
Engineering, 04.07.2019 19:20
Apure substance is a)-mixture of various chemical elements or compounds b)-substance that has a fixed chemical composition throughout c)-mixture that is homogeneous (such as air) d)-all the answers
Answers: 3
You know the right answer?
A shaft and hole have a nominal diameter of 1 in. The shaft has a tolerance of 0.003in, the hole has...
Questions
question
Chemistry, 20.04.2021 16:10
question
Mathematics, 20.04.2021 16:10
question
Mathematics, 20.04.2021 16:10
question
Mathematics, 20.04.2021 16:10
Questions on the website: 13722360