subject
Engineering, 27.03.2021 14:10 biancabell3

Air flows adiabatically in a converging duct, which is fed from a large reservoir where the temperature and the pressure are 305 K and 210 kPa, respectively. At the end of the duct,
where the cross-sectional area is 0.0025 the pressure and temperature are 172 kPa and
278 K, respectively, Determine the Mach number at the end of the duct and find the mass
flow rate.​

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
question
Engineering, 04.07.2019 18:10
Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan
Answers: 3
question
Engineering, 06.07.2019 03:20
Major ingredients of traditional ceramics (a) silica (b) clay (c) feldspar (d) all
Answers: 1
question
Engineering, 06.07.2019 03:30
The catalogue for a refrigerant 22, four-cylinder, hermetic compressor operating at 29 r/s. a condensing temperature of 40°c and an evaporating temperature of -4°c shows a refrigeration capacity of 115 kw. at this operating point, the motor (its efficiency is 90 percent) draws 34.5 kw. the bore of the cylinders is 87 mm and the piston stroke is 70 mm. the performance data are based on 8°c of sub-cooling of the liquid leaving the condenser. compute (a) the actual volumetric efficiency and (b) the compression efficiency.
Answers: 2
You know the right answer?
Air flows adiabatically in a converging duct, which is fed from a large reservoir where the tempera...
Questions
question
Mathematics, 14.10.2019 14:10
Questions on the website: 13722359