Engineering, 29.03.2021 18:10 sumitshekhar348
Referring to the figure above, the inside diameter machining marks
A. will be perpendicular to the axis.
B. will be parallel to the axis of the tube.
C. can be no higher than 63 micro-inches in any direction.
D. must be removed after machining
click on full diagram
Answers: 3
Engineering, 03.07.2019 14:10
Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned
Answers: 2
Engineering, 03.07.2019 23:20
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
Engineering, 04.07.2019 16:10
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
Engineering, 04.07.2019 18:10
Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.
Answers: 3
Referring to the figure above, the inside diameter machining marks
A. will be perpendicular to the...
Mathematics, 13.07.2019 21:00
Mathematics, 13.07.2019 21:00
Mathematics, 13.07.2019 21:00
Mathematics, 13.07.2019 21:00
Biology, 13.07.2019 21:00
English, 13.07.2019 21:00
Mathematics, 13.07.2019 21:00
Mathematics, 13.07.2019 21:00