Engineering, 30.03.2021 23:30 kimlyn58p0wyn0

The defrost of an automobile function by discharging warm air on the inner surface of windshield. To prevent condensation of water on the inner surface, the temperature of the air and surface convection coefficient must be large enough to maintain a surface termperature Ts, i that is at least as high as the dew point temperature, Ts, i > Tdewp. Consider a windshield of length L=800 mm, and thickness t=6 mm, and driving conditions for which the vehicle moves at velocity of V=162 Km/h in ambient air at -15°C. The average convective heat trasfer coefficient on the outside of the windshield may be determined from the correlation. NuL=0.0295.Re^0.8LPr^1/3

Required:
a. If Tdewp=10 and T[infinity],i=50CC, what is the smallest value for hihi required to prevent condensation the inner surface.
b. Plot the thermal equivalent circuit. write the thermal resistances on the circuit

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

Engineering, 04.07.2019 18:10

At 12 noon, the count in a bacteria culture was 400; at 4: 00 pm the count was 1200 let p(t) denote the bacteria cou population growth law. find: (a) an expression for the bacteria count at any time t (b) the bacteria count at 10 am. (c) the time required for the bacteria count to reach 1800.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?

Answers: 3

Answer

Engineering, 04.07.2019 19:20

To save energy, the air supply to a 2000 ft office has been shut off overnight and the room temperature has dropped to 40°f. in the morning, the thermostat is reset to 70°f and warm air at 120 f begins to flov in at 200ft'/min. the air is well mixed within the room, and an equal mass flow of air at room temperature (changing with time) is withdrawn through a return duct. the air pressure is nearly 1 atm everywhere. ignoring heat transfer with the surroundings and kinetic and potential energy effects, estimate how long it takes for the room temperature to reach 70°f. plot the room temperature as a function of time.

Answers: 1

Answer

You know the right answer?

The defrost of an automobile function by discharging warm air on the inner surface of windshield. To...

Questions