subject
Engineering, 02.04.2021 01:00 kale2158

Describe how a cavity wall works and sketch its major construction features. What aspects of cavity wall construction are most critical to its success in preventing water leakage? Where should flashings be installed in a masonry wall? What is the function of the flashing in each of these locations? Where should weep holes be provided? Describe the function of a weep hole and indicate several ways in which it may be constructed. What types of movement joints are required in a concrete masonry wall? In a brick masonry wall? Where should these joints be located? What are some ways of insulating masonry walls? What precautions should be taken when constructing masonry walls in Minneapolis in the winter?

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 19:10
In general, how do thermosetting plastics compare to thermoplastics in mechanical and physical properties?
Answers: 3
question
Engineering, 04.07.2019 19:10
What is the chief metrological difference between measuring with a microscope and with an electronic comparator? a. the microscope is limited to small workpieces.a. the microscope is limited to small workpieces. c. the comparator can only examine one point on the workpiece. d. the microscope carries its own standard.
Answers: 1
question
Engineering, 04.07.2019 19:20
In the winter, in order to keep the classroom steadily at 68 f before 10 pm, heating with an average rate of 42,000 btu/hr is provided. assume the outdoor temperature maintains at 32°f, determine the electrical power (kw) required to (a) operate a reversible heat pump (b) operate a real heat pump with a cop (7) of 4.5 and (c) operate an electrical-resistance heater.
Answers: 3
question
Engineering, 06.07.2019 02:30
An electric motor is used to drive a power press which makes steel turning moment diagrams 323 pressings from a metal sheet. the motor runs at a mean speed of 50 rev/s. the torque required is 10.0nm for 0.2s, followed by 1.0nm for0.3 s with this sequence then being repeated. what is the minimum power required of the motor and the moment of incrtia required for the t1ywhcel if the speed fluctuations are to be restricted to 1.5%?
Answers: 3
You know the right answer?
Describe how a cavity wall works and sketch its major construction features. What aspects of cavity...
Questions
question
Social Studies, 04.11.2020 16:30
question
Mathematics, 04.11.2020 16:30
question
Physics, 04.11.2020 16:30
question
Social Studies, 04.11.2020 16:30
question
Mathematics, 04.11.2020 16:30
question
World Languages, 04.11.2020 16:30
question
Arts, 04.11.2020 16:30
Questions on the website: 13722361