Engineering, 02.04.2021 22:40 DWilson1234
A transect of piezometers have been drilled into a deep, confined aquifer composed of sand. For a porosity of 30% and a hydraulic conductivity of 32.8 m/d, estimate the specific discharge, actual velocity, and time of travel for the water to move 5km from its recharge zone.
Piezometer Head (m) Distance (km)
1 50 0
2 45 2.5
3 40 5
Answers: 1
Another question on Engineering
Engineering, 04.07.2019 03:10
What precautions should you take to prevent injuries when dealing with heavy loads?
Answers: 1
Engineering, 04.07.2019 18:10
Abrake has a normal braking torque of 2.8 kip in and heat-dissipating cast-iron surfaces whose mass is 40 lbm. suppose a load is brought to rest in 8.0 s from an initial angular speed of 1600 rev/min using the normal braking torque; estimate the temperature rise of the heat dissipating surfaces.
Answers: 3
Engineering, 04.07.2019 18:10
Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)
Answers: 1
Engineering, 04.07.2019 18:10
Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i.d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.
Answers: 3
You know the right answer?
A transect of piezometers have been drilled into a deep, confined aquifer composed of sand. For a po...
Questions
Physics, 16.12.2019 23:31
Social Studies, 16.12.2019 23:31
Biology, 16.12.2019 23:31
Health, 16.12.2019 23:31
Social Studies, 16.12.2019 23:31
