Engineering, 05.04.2021 17:50 kallie862

Q2. Figure 1 shows the floor plan of a proposed G+2 office building. It consist of one-way slabs spanning between beams on grid lines A, B, C and D. At this stage as a structural engineer you
should design end span of the slab with Leff = 6 m, considering the design loads for the floor
(excluding the self-weight) includes a superimposed dead load (SDL) of 1.5 kN/m² to account
for finishes, ceiling etc and live load 6+(W/10) (Last 2 digits of your id). In addition, a 0.8 kN/m
wall load is applied around the building perimeter and on the beams located internally. Consider
the ends of the slab to be simply supported. Design the flexural reinforcement in the middle of
the end span, check for shear and deflection for the slab according to BS 8110 code provisions.
Consider the overall depth of slab as 200 mm and 12 mm bars along both directions.

the last digits of the Id=71

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

What are the two (02) benefits, which may result from a successful implementation of preventive maintenance (pm) program in an organization? (clo3)a)- lean manufacturing b)-overlapping responsibilities c)-the planner is not qualified d)-accurate contractor information e)-reduction in equipment redundancies f)-accurate stores information

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Ahe-xe mixture containing a 0.75 mole fraction of helium is used for cooling electronics in an avionics application. at a temperature of 300 k and atmospheric pressure, calculate the mass fraction of helium and the mass density, molar concentration and molecular weight of the mixture. if the cooling capacity is 10 l, what is the mass of the coolant?

Answers: 3

Answer

You know the right answer?

Q2. Figure 1 shows the floor plan of a proposed G+2 office building. It consist of one-way slabs sp...

Questions