subject
Engineering, 05.04.2021 23:50 smilebehappy468

Ethylene hydrogenation The hydrogenation of ethylene to hydrogen is found experimentally to follow the reaction orders given in the following table 341. 270 Chemical Kinetics Rh Catalyst Order in H2Order in CH4 0.85 -0.74 0.95 -0.59 0.55 -0.19 Ru The following steps have been suggested for the catalytic reaction mecha- nism (39. p.53). In this mechanism ethylene adsorbs associatively and H2 adsorbs dissociatively. There is a stepwise addition of adsorbed hydrogen to form an adsorbed ethyl group, C2H5 ads, and then adsorbed ethane, CyH6ynds. CH4 + S C Heads H2 + 25 2Hads C2H4.ads + Heds C2Hs ads +S CH5.ds + Hade C2H6,ads + S CzH6, ads CzH. where Sis a vacant surface site. The rate of the formation of ethane is that of the rate limiting surface hydrogenation step. There are two choices. For Scheme I, the rate limiting step is Reaction 3. For Scheme II, the rate limiting step is Reaction 4. 1. Develop a rate expression for the rate of ethane formation for Scheme 1. Let Reaction 3 be the rate-limiting step and assume all other reactions are at equilibrium. Assume that adsorptionfrom the gas phase follows a Langmuir adsorption isotherm. Neglect the reverse of Reaction 3. When performing a site balance, assume the surface is either vacant or covered with adsorbed ethylene, i. e., the coverage of ethyl, atomic hydrogen and adsorbed ethane are negligibly small 2. Develop a rate expression for the rate of ethane formation for Scheme 11. Let Reaction 4 be the rate-limiting step and assume all other reactions are at equilibrium. Assume that adsorption from the gas phase follows a Langmuir adsorption isotherm Neglect the reverse of Reaction 4. When performing a site balance, assume the surface is either vacant or covered with adsorbed ethylene and ethyl, i. e, the coverage of atomic hydrogen and adsorbed ethane are negligibly small 3. Based on the experimental data listed in the table, is Schemelor ll the more probable mechanism and why?

ansver
Answers: 2

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
question
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
question
Engineering, 04.07.2019 18:20
Inadequate stores control is not an obstacle to effective work order system. (clo4) a)-true b)-false
Answers: 3
question
Engineering, 04.07.2019 18:20
How much power could a wind turbine produce if it had the following specifications? cp = 0.45 -d=1.2kg/m3 d=50m v 5m/s
Answers: 2
You know the right answer?
Ethylene hydrogenation The hydrogenation of ethylene to hydrogen is found experimentally to follow t...
Questions
question
English, 20.09.2019 00:30
question
Chemistry, 20.09.2019 00:30
question
Business, 20.09.2019 00:30
Questions on the website: 13722363