subject
Engineering, 06.04.2021 03:30 farhan61

Below is a topology for a typical variation of the Colpitts oscillator. Assume you want this oscillator to run at a center frequency of 7.5 MHz where C1 can be used for fine tuning. You have available the following standard +/- 10% tolerance capacitor values that you could use for C3 and C4. Which value should you pick? a. 270 pF
b. 330 pF
c. 390 pF
d. 470 pf
e. 560 pf
f. 680 pf
g. 820 pF
h. 910 pF
i. 1000 pF
j. 1200 pF

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
The temperature of air decreases as it is compressed by an adiabatic compressor. a)- true b)- false
Answers: 2
question
Engineering, 04.07.2019 18:10
Different types of steels contain different elements that alter the characteristics of the steel. for each of the following elements, explain what the element does when alloyed with steel.
Answers: 2
question
Engineering, 04.07.2019 18:10
Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way
Answers: 2
question
Engineering, 04.07.2019 18:20
Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?
Answers: 2
You know the right answer?
Below is a topology for a typical variation of the Colpitts oscillator. Assume you want this oscilla...
Questions
question
History, 20.03.2020 07:35
Questions on the website: 13722367