Engineering, 07.04.2021 20:50 breana758

Boost converter. 1 In the 2010 Toyota Prius, a Boost converter is used to step up the output voltage of the bat- tery (assumed to be constant and equal to 200 V). Three dc-bus voltage levels are used: VDC 250 V, VDc= 500 V, and Vpc = 650 V. Assuming the Boost converter to be ideal, what are the three duty cycles required to meet the steady-state requirements? 2 Assuming that the power of the Boost converter in 4.1 is 20 kW, define the input and output currents corresponding to cach case. And the same question with 40 kW. 3 We want to size the inductor to ensure maximum input current ripple of 10%. What are the allowed ripple levels (peak-to-peak) and the requirements for the inductance for the Boost in 4.1 if the switching frequency is 10 kHz (case 20 kW)? 4 If the load of the Boost in 4.1 is a pure resistor, what should be its value to absorb 20 kW if Vpc = 650 V? 5 Assuming that the inductance found in 4.3 and the load resistor found in 4.4 are selected, what is the required capacitance to ensure less than 10% voltage ripple? DC

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Manometers are good examples of measuring instruments, nowadays they are not as common as before. a)-capacitive probe gauges b)-gravitational gauges deformation ) gauges d)-digital gauges

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Athin walled concentric tube exchanger is used to cool engine oil from 160°c to 60°c with water that is available at 25°c acting as a coolant. the oil and water flow rates are each at 2 kg/s, and the diameter of the inner tube is 0.5 m and the corresponding value of the overall heat transfer coefficient is 250 w/m2. oc. how long must the heat exchanger be to accomplish the desired cooling? cpwater=4.187 kj/kg-candcpengine el=2.035 kj/kg·°c, oil . 120]

Answers: 1

Answer

Engineering, 04.07.2019 18:20

For each of the following process: a) sketch the p-v diagram, b)sketch t-s diagram, c) sketch t-v diagram, d) sketch the boundary work on one of the diagrams (a, b or c) and e) sketch the reversible heat transfer on one of the diagrams (a, b or c): 1- isobaric process from compressed liquid to superheated vapor 2- isothermal process from compressed liquid to superheated vapor 3- isentropic process from compressed liquid to superheated vapor

Answers: 3

Answer

Engineering, 06.07.2019 02:30

1in2 processor chip can be modelled as an isothermal plane wall of silicon, isothermal on both sides. the power input to the bottom of the plane wall, or the processing power of the chip, often called the thermal design power (tdp), is 100w. assume the periphery is adiabatic. the silicon is 400 microns thick. the temperature at the junction, or in this case on the bottom of the isothermal plane wall, is 85°c. what is the top surface temperature, assuming that the only mode of heat transfer is conduction

Answers: 1

Answer

You know the right answer?

Boost converter. 1 In the 2010 Toyota Prius, a Boost converter is used to step up the output voltage...

Questions