subject
Engineering, 08.04.2021 03:50 jinjuwdjesus

Question 13 Object "m" is suspended by a string (string 1) connected to the ceiling. String 2 connects "m1" to another object "m2" below it. Each object has a mass of 20kg.
a. Sketch the objects showing the masses and strings.
b. Draw the Free Body Diagram for each mass, and label each force.
c. Are either (or both) masses in equilibrium? Why?
d. What is the tension in string 2 Show your work.
What is the tension in string 1 Show your work.
f. Which tension is greater and why?

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:10
Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false
Answers: 3
question
Engineering, 04.07.2019 18:20
Air flows over a heated plate àt a velocity of 50m/s. the local skin factor coefficient at a point on a plate is 0.004. estimate the local heat transfer coefficient at this point.the following property data for air are given: density = 0.88kg/m3 , viscosity 2.286 x 10 ^-5 kgm/s , k = 0.035w/mk ,cp = 1.001kj/kgk. use colburn reynolds analogy.
Answers: 1
question
Engineering, 04.07.2019 19:10
An engine, weighing 3000 n, is supported on a pedestal mount. it has been observed that the engine induces vibration into the surrounding area through its pedestal at the maximum operating speed. determine the stiffness of the dynamic vibration absorber spring in (n/m) that will reduce the vibration when mounted on the pedestal. the magnitude of the exciting force is 250 n, and the amplitude of motion of the auxiliary mass is to be limited to 2 mm note: in this question type-in right numbers, no decimals, no fractions, no unit. approximate to right number if needed
Answers: 3
question
Engineering, 06.07.2019 04:10
Aheat pump using refrigerant-134a heats a house by using underground water at 8°c as the heat source. the house is losing heat at a rate of 60,000 kj/h. the refrigerant enters the compressor at 280 kpa and 0°c, and it leaves at 1 mpa and 60°c. the refrigerant exits the condenser at 30°c. determine: (a) the power input to the heat pump, (b) the rate of heat absorption from the water, and (c) the increase in electric power input if an electric resistance heater is used instead of a heat pump
Answers: 2
You know the right answer?
Question 13 Object "m" is suspended by a string (string 1) connected to the ceiling. String 2 conne...
Questions
question
Mathematics, 17.04.2020 16:21
question
Mathematics, 17.04.2020 16:21
question
Mathematics, 17.04.2020 16:42
Questions on the website: 13722361