Engineering, 09.04.2021 02:00 arnold2619

Assume the units of t are hours. a. Use Matlab to determine the equation for velocity of the weather balloon, using the fact that the velocity is the derivative of the altitude. b. Use Matlab to determine the equation for the acceleration of the weather baloon, using the fact that the acceleration is the derivative of the velocity. c. Use Matlab to determine when the balloon hits the ground. Because h(t) is a fourth-order polynomial, there will be four answers. However, only one answer will be physically meaningful. d. Use Matlab's symbolic plotting capability to create plots of altitude, velocity and acceleration from time zero until the balloon hits the ground. You'll need three separate plots, since altitude, velocity and acceleration all have different units. 2 e. Determine the maximum height reached by the balloon. Use the fact that the velocity of the balloon is zero at the maximum height.

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Apiston-cylinder with a volume of 0.25 m3 holds 1 kg of air (r 0.287 k/kgk) at a temperature of 100 c. heat transfer to the cylinder causes an isothermal expansion of the piston until the volume triples. how much heat is added to the piston-cylinder?

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Compute the pressure drop of 30°c air flowing with a mean velocity of 8 m/s in a circular sheet-metal duct 300 mm in diameter and 15 m long. use a friction factor, f 0.02, and pair = 1.1644 kg/m a. 37.26 pa b. 25.27 pa n c. 29.34 pa d. 30.52 pa

Answers: 1

Answer

Engineering, 04.07.2019 19:20

To design a steam turbine to produce 12,000 hp power. a engineer comsiders using a steady state stean low st 1160fr and engineer considers using a steady state steam flow at 1160°r and 450 psia to drive this steam turbine. the exhaust of the steam is cooled by the lake (vacuum). heat losing to the surroundings is measured at a rate of 555.55 btu/s. (a) sketch the system with the given conditions. (b) neglecting kinetic and potential energy changes from inlet to exit, determine the volumetric flow rate of the steam at the inlet, (ft'/hr). must clearly show unit conversions at crtical terms.

Answers: 1

Answer

You know the right answer?

Assume the units of t are hours. a. Use Matlab to determine the equation for velocity of the weather...

Questions