Engineering, 13.04.2021 01:00 juliopejfuhrf7541
A solid square rod is cantilevered at one end. The rod is 0.8 m long and supports a completely reversing transverse load at the other end of ±1.3 kN. The material is AISI 1080 hot-rolled steel. If the rod must support this load for 3 × 104 cycles with a design factor of 1.5, what dimension should the square cross section have? Neglect any stress concentrations at the support end.
Answers: 2
Another question on Engineering
Engineering, 04.07.2019 18:10
During a steady flow process, the change of energy with respect to time is zero. a)- true b)- false
Answers: 2
Engineering, 04.07.2019 18:10
Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.
Answers: 3
Engineering, 04.07.2019 18:10
Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.
Answers: 1
Engineering, 04.07.2019 18:10
Assuming compressible flow of air and that the measurements are done at flagstaff a pitot static tube that gives the difference of total and static pressure measures 0.35 m of mercury. what is the velocity of air? assume the temperature to be 300k. (submit your excel or matlab calculation sheet)
Answers: 1
You know the right answer?
A solid square rod is cantilevered at one end. The rod is 0.8 m long and supports a completely rever...
Questions
Advanced Placement (AP), 15.01.2021 18:10
Mathematics, 15.01.2021 18:10
Mathematics, 15.01.2021 18:10
English, 15.01.2021 18:10
Mathematics, 15.01.2021 18:10
Mathematics, 15.01.2021 18:10
Mathematics, 15.01.2021 18:10
Chemistry, 15.01.2021 18:10
English, 15.01.2021 18:10
English, 15.01.2021 18:10
Mathematics, 15.01.2021 18:10
Social Studies, 15.01.2021 18:10
