Engineering, 13.04.2021 20:10 vkyles84

Design a parallel resonant circuit for an AM radio receiver. The inductance can vary to adjust the resonant frequency in order to cover the full AM broadcast band, which is from 530 to 1610 kHz. The circuit bandwidth must be at least 20 kHz in order to reproduce the full station signal, but not too much more than that in order to filter out adjacent stations. The resistor value is 33 kΩ. The inductance varies with a fixed inductor Lfixed in series with a variable inductor that has a range from zero to Lvar in order to cover the broadcast band. Using standard 20% tolerance commercial values, obtain the value of the capacitor and the two inductors. Finally, determine the quality factor range of the circuit from the low end to the high end of the broadcast band. Given: w = 2pif, w0 = 1/sqrt(LC), B = w0/Q, Q = w0RC

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Machinery that is a key part of the process and without which the plant or process cannot function is classifed as: (clo4) a)-critical machinery b)-essential machinery c)-general purpose machinery d)-none of the specified options.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?

Answers: 3

Answer

You know the right answer?

Design a parallel resonant circuit for an AM radio receiver. The inductance can vary to adjust the r...

Questions