Engineering, 15.04.2021 21:20 oneicyahdaley10
Select the correct answer.
Which tool helps record specific data during the initial stages of operations?
A. histogram
B. control chart
C. check sheet
D. Pareto chart
E. scatter diagram
Answers: 3
Another question on Engineering
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Engineering, 04.07.2019 18:20
Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency
Answers: 1
Engineering, 04.07.2019 18:20
Wiy doeres rere okhn a pump whon working betwon the same pressure range?
Answers: 2
Engineering, 04.07.2019 18:20
Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa.s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)
Answers: 3
You know the right answer?
Select the correct answer.
Which tool helps record specific data during the initial stages of opera...
Questions
Mathematics, 18.01.2021 22:30
Mathematics, 18.01.2021 22:30
Mathematics, 18.01.2021 22:30
Mathematics, 18.01.2021 22:30
Physics, 18.01.2021 22:30
Physics, 18.01.2021 22:30
Mathematics, 18.01.2021 22:30
Chemistry, 18.01.2021 22:30
