Engineering, 15.04.2021 23:50 svaskeacevilles5477
(a) Calculate minimum water flow rate (L’min) to perform the operation. If a multistage/multitray absorber column was used for the above process, how many trays/stages (N) will be required to perform the required operation? Calculate and show the concentrations after each stage. (b) If the actual liquid rate is 1.4 times the minimum value, what is the outlet liquid composition (XN)? (Hint: Do not calculate the number of trays/stages and concentrations for each stage. Try to infer from mass balances/operating line equation.) (c) If the actual liquid rate is 1.4 times the minimum value, solve for the actual number of trays using graphical methods/EXCEL/MATLAB/MATHCAD etc. Calculate and show the concentrations after each stage. (d) If the actual liquid rate is 1.4 times the minimum value, solve for the actual number of trays using the Kremser relationship
Answers: 2
Another question on Engineering
Engineering, 04.07.2019 18:20
Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency
Answers: 1
Engineering, 04.07.2019 19:10
The proportional limit is always greater than the yield strength for a material. a)-trune b)- false
Answers: 3
Engineering, 06.07.2019 02:30
On solidification from a melt, the polymer polyethylene forms a semi-crystalline spherulite structure. (i) sketch an individual spherulite and label the amorphous and crystalline regions. (ii) draw a schematic to show the changes in specific volume with temperature during cooling from the melt, comparing it to the theoretical extremes of fully crystalline and fully amorphous (indicate tm and tg)
Answers: 2
Engineering, 06.07.2019 03:10
Steel balls 12 mm in diameter are annealed by heating to 1150 k and then slowly cooled to 400 k in an air att 325 k and h -20 w/m2 k. assume the properties of the steel to be k- 40 w/m k,p 7800 kg/m3, and cp 600 j/kg k. a. determine whether lumped system method can be used to analyze this problem and if so why" b. determine the time required for the cooling process. c. determine the total amount of heat lost from each ball to the ambient air
Answers: 1
You know the right answer?
(a) Calculate minimum water flow rate (L’min) to perform the operation. If a multistage/multitray ab...
Questions
