Engineering, 17.04.2021 21:20 oomale
In the lecture, four computational mechanics processes were presented: 1. Comparative Iterations 2. Algorithmic 3. Finite Elements Software like ABAQUS and ANSYS 4. Generative design like Autodesk Assign the processes listed above to the key statements outlined below. Every key statement can apply to more than one process. For example, if statement (a) below applies to computational mechanics processes 1 and 2, write down the following: Statement (a) applies to processes 1 and 2 Homework #5 – Using Computation MECE 2361 - Introduction to Mechanical Design Key statements:
a) Requires CAD representation of the design
b) Requires definition of the inputs, outputs
c) Requires definition of the initial conditions and boundary conditions.
d) Software is used to track different iterations of different inputs, changes in output are compared.
e) Require evaluation of the results and good engineering interpretation
f) Requires knowledge in Finite Estimation (Discretization of the continuous mathematical model using a mathematical numerical analysis method)
g) Requires knowledge in Algorithmic programming
h) Generates the design for you based on the specified constraints
i) Requires parallel computing for fast large calculations
j) Require validation of the results with experimental results, analytical calculation or benchmark problems
Answers: 3
Engineering, 03.07.2019 14:10
When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point
Answers: 3
Engineering, 04.07.2019 18:10
The temperature of air decreases as it is compressed by an adiabatic compressor. a)- true b)- false
Answers: 2
Engineering, 04.07.2019 18:10
Ariver flows from north to south at 8 km/h. a boat is to cross this river from west to east at a speed of 20 km/h (speed of the boat with respect to the earth/ground). at what angle (in degrees) must the boat be pointed upstream such that it will proceed directly across the river (hint: find the speed of the boat with respect to water/river)? a 288 b. 21.8 c. 326 d. 30.2
Answers: 3
Engineering, 04.07.2019 18:20
Acertain flow of air (at stp) has a velocity distribution given by v i (in ft/s). if this flow is going through a 4 ft square area in the yz-plane (centered at the origin), what is the mass flow rate (in lbm/s)?
Answers: 2
In the lecture, four computational mechanics processes were presented: 1. Comparative Iterations 2....
History, 23.03.2020 03:43
English, 23.03.2020 03:44
History, 23.03.2020 03:44
Mathematics, 23.03.2020 03:44
Biology, 23.03.2020 03:44
History, 23.03.2020 03:45
Mathematics, 23.03.2020 03:45
Mathematics, 23.03.2020 03:45
Mathematics, 23.03.2020 03:46
Advanced Placement (AP), 23.03.2020 03:46
Advanced Placement (AP), 23.03.2020 03:46