Going too slow on the band will
• make better cuts
• cause the stock to burn
• reduce...
Engineering, 29.04.2021 18:40 dondre54
Going too slow on the band will
• make better cuts
• cause the stock to burn
• reduce accuracy
• none of the above
The stock being cut (band saw) cannot be
• held flat
• strait
• wood
• turned sharply
For sharp cuts, you must make several cuts from the outside edge
• fast
• open
• sharp
• relief
The band saw guard should be above the wok piece.
• 1 inch
• 2 inches
• 1/2 inches
• 1/4 inches
Where should your fingers be when cutting on the band saw?
• anywhere as long as the stock is well supported
• pointing away from the blade
• must use mitre gauge and should not have hands on the table
• push stock with hands towards the blade of band saw
Answers: 2
Engineering, 03.07.2019 15:10
Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.
Answers: 1
Engineering, 04.07.2019 03:10
What precautions should you take to prevent injuries when dealing with heavy loads?
Answers: 1
Engineering, 04.07.2019 18:10
Steel is coated with a thin layer of ceramic to protect against corrosion. what do you expect to happen to the coating when the temperature of the steel is increased significantly? explain.
Answers: 1
Engineering, 04.07.2019 18:10
Burgers vector is generally parallel to the dislocation line. a)-true b)-false
Answers: 2
Advanced Placement (AP), 28.04.2021 06:50
Mathematics, 28.04.2021 06:50
Computers and Technology, 28.04.2021 06:50
History, 28.04.2021 06:50
English, 28.04.2021 06:50
Social Studies, 28.04.2021 06:50
Mathematics, 28.04.2021 06:50
Chemistry, 28.04.2021 06:50
History, 28.04.2021 06:50