Engineering, 29.04.2021 22:50 KaleahV

1. Noise usually caused by the solenoid closing or the pinion gear contacting the flywheel gear. 2. Can operate the lights but may not have enough power to operate the starting motor. 3. Condition where the engine crankshaft does not rotate when the ignition key is turned to the start position. 4. Sound caused by low current flow making the solenoid plunger rapidly kick in and out. 5. Condition that occurs when the engine crankshaft rotates at speeds that are lower than normal. 6. Quickly locates a part with higher-than-normal resistance. 7. Allows the armature to drag or rub on the field pole shoes. 8. Used to check the circuit between the starting motor ground and the negative battery terminal. 9. Distance between pinion and drive end frame with pinion engaged. 10. Used to adjust the space between the pinion gear and the flywheel ring gear.

Answers: 1

Show answers

Another question on Engineering

Engineering, 03.07.2019 23:20

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

Answer

Engineering, 04.07.2019 18:10

Machinery that is a key part of the process and without which the plant or process cannot function is classifed as: (clo4) a)-critical machinery b)-essential machinery c)-general purpose machinery d)-none of the specified options.

Answers: 1

Answer

You know the right answer?

1. Noise usually caused by the solenoid closing or the pinion gear contacting the flywheel gear. 2....

Questions