Engineering, 01.05.2021 01:30 quynhnguyen7454

The following two DC motors are to be compared for certain application: Motor A: 250 V Shunt motor with 0.2 ohm armature resistance, 125 ohm field resistance, and has a full load operation with 50 armature Amps at 1000 rpm.
Motor B: 250 V Series motor with 0.2 ohm armature resistance, 0.1 ohm field resistance, and has a full load operation with 50 armature Amps at 1000 rpm

Required:
a. While running at full load, what will be the reduction in speed if the load torque is increased by
b. While running at full load, what will be the change in torque if the speed drops by 20%?
c. The added armature starting resistance to start the motor at 200% Of its rated armature current, and what is the corresponding starting torque?
d. What is the starting resistance cut and the motor speed, when the armature current becomes in order to bring the armature current back to the level to continue with its Starting?

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Which of the following refers to refers to how well the control system responds to sudden changes in the system. a)-transient regulation b)- distributed regulation c)-constant regulation d)-steady-state regulation

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Journeyman training is usually related (clo2) a)-to specific tasks b)-to cost analysis of maintenance task c)-to control process to ensure quality d)-to installation of machinery

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?

Answers: 2

Answer

You know the right answer?

The following two DC motors are to be compared for certain application: Motor A: 250 V Shunt motor...

Questions