Engineering, 02.05.2021 04:40 em387p3s1zr

You are tasked with designing a lock for a dog door. The door has fouruser settings: (1) The door opensfor any animalthat approaches via a motion sensor; (2) The door opens when dog approaches via a motion sensor and the dog has a proper collar RFID. This will allow only specific dogs in; (3) The door is always locked. This is useful for nighttimeand vacations; (4) The door is always open unless a cat approaches via a camera system. To avoid false positives, the motion sensor must detect an animal approaching and the RFID sensor must be negativeto close. This is an expensive addon for people who paranoid a cat might come in the house. a) Write a simplified statement for the prompt
b) Write a Boolean expression.
c) Draw the circuit diagram
d) If I asked for a truth table, how many rows would it have?

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Athin walled concentric tube exchanger is used to cool engine oil from 160°c to 60°c with water that is available at 25°c acting as a coolant. the oil and water flow rates are each at 2 kg/s, and the diameter of the inner tube is 0.5 m and the corresponding value of the overall heat transfer coefficient is 250 w/m2. oc. how long must the heat exchanger be to accomplish the desired cooling? cpwater=4.187 kj/kg-candcpengine el=2.035 kj/kg·°c, oil . 120]

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Determine the damped natural frequencies and the steady state response of a decoupled damped forced two degrees of freedom system. 10ä1 + 2q1 20q1 10 cos t; 10q2 +4q2 + 40q2 10 cos t

Answers: 3

Answer

You know the right answer?

You are tasked with designing a lock for a dog door. The door has fouruser settings: (1) The door op...

Questions