Engineering, 03.05.2021 19:20 peteh5

Hurry help 30 points Project: Reverse Engineering Documentation and Presentation Assignment Directions

Engineers usually work in teams with members who do not have the same level of technical knowledge. They rely on visual and graphic aids to explain and support their communication efforts. To practice these skills, write a 3- to 5-page paper that describes your suggestions for a reverse engineering project. You do not need to complete the reverse engineering project. You are presenting instead an evaluation of a product that you believe could be improved. This may include an object or product that you have reverse engineered in the past or a product that you would someday like to analyze.

Include two of the following visual and graphic aids:

Product Teardown Chart (if completed)
Function Structure Diagram
Exploded View Diagram
Morphological Matrix
Design Decision Matrix
The visual aids are not just supplemental to your presentation. They must be incorporated into your reasoning as you make design modification suggestions.

Assignment Guidelines

a written analysis or a script for an oral presentation
two visual or graphic aids that support the presentation
Submission Requirements:

3 to 5 pages double spaced

Proper grammar and vocabulary is required.

Answers: 1

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Avolume of 2.65 m3 of air in a rigid, insulated container fitted with a paddle wheel is initially at 264 k, 5.6 bar. the air receives 432 kj by work from the paddle wheel. assuming the ideal gas model with cv = 0.71 kj/kg • k, determine for the air the amount of entropy produced, in kj/k

Answers: 2

Answer

Engineering, 04.07.2019 18:20

Refrigerant-134a enters the compressor of a refrigerator as superheated vapor at 0.14 mpa and -10°c at a rate of 0.05 ka/s and leaves at 0.8 mpa and 50°c. the refrigerant is cooied in the condenser to 0.72 mpa and 26'c. it is then throttled to 0.15 mpa. sketch the t-s diagram for the system and evaluate: 6) the rate of heat removai from the refrigerated space (kw), it) the power input to the compressor (kw), ii) the isentropic efficiency of the compressor (%), and iv) the cop of the refrigerator.

Answers: 2

Answer

You know the right answer?

Hurry help 30 points Project: Reverse Engineering Documentation and Presentation Assignment Direct...

Questions