Engineering, 12.05.2021 04:00 iisofieii1978

Answer TRUE or FALSE regarding the optimum design criteria of 7TZP thermal barrier coatings for jet engine turbine blades? The yttria content of the top coat layer (columnar grains) should be maximized and should exceed at least 15 wt% in the ceramic.
The yttria content of the bonding layer should be maximized and should exceed at least x = 1.0 within a bonding layer of Ni-16-Cr-5Al-xY.
The coefficients of thermal expansion for the TBC sublayers should be matched as close as possible to prevent thermal stresses that could promote cracking and spalling of the TBC. [Select] The thermal conductivities of the TBC sublayers should be matched as close as possible to the underlying base metal (usually a Ni-based superalloy).
Air gaps between grains of top coat 7TZP should be minimized, since they act as stress concentrators for each of the as-grown grains.
Soda-lime glass is the preferred composition for the bonding layer of modern columnar TBCs.

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 15:10

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Answers: 1

Answer

Engineering, 04.07.2019 08:10

Which of the following is an easy way to remember the modified “x” tire rotation? a. nondrive wheels straight, cross the drive wheels b. drive wheels straight, cross the nondrive wheels c. drive wheels crossed, nondrive wheels straight d. drive wheels crossed, nondrive wheels crossed

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

Answer

Engineering, 04.07.2019 18:10

During a steady flow process, the change of energy with respect to time is zero. a)- true b)- false

Answers: 2

Answer

You know the right answer?

Answer TRUE or FALSE regarding the optimum design criteria of 7TZP thermal barrier coatings for jet...

Questions