Answers: 2
Another question on Engineering
Engineering, 03.07.2019 14:10
Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned
Answers: 2
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Engineering, 04.07.2019 18:20
Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis
Answers: 1
Engineering, 04.07.2019 18:20
A2-m rigid tank initially contains saturated water vapor at 100 kpa. the tank is connected to a supply line through a valve. steam is flowing in the supply line at 600 kpa and 300 c. the valve is opened, and steam is allowed to enter the tank until the pressure in the tank reaches the line pressure, at which point the valve is closed. a thermometer placed in the tank indicates that the temperature at the final state is 200°c. determine (a) the mass of steam that has entered the tank (b) the amount of heat transfer.
Answers: 3
You know the right answer?
M, ojknionhubyu9bybv9u8...
Questions
Mathematics, 16.07.2019 13:30
Biology, 16.07.2019 13:30
Mathematics, 16.07.2019 13:30
Biology, 16.07.2019 13:30
History, 16.07.2019 13:30
Mathematics, 16.07.2019 13:30
Chemistry, 16.07.2019 13:30
Physics, 16.07.2019 13:30
Mathematics, 16.07.2019 13:30
English, 16.07.2019 13:30
Social Studies, 16.07.2019 13:30
History, 16.07.2019 13:30
English, 16.07.2019 13:30
Mathematics, 16.07.2019 13:30
