Answers: 1
Another question on Engineering
Engineering, 04.07.2019 16:10
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
Engineering, 04.07.2019 18:10
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:10
Manometers are good examples of measuring instruments, nowadays they are not as common as before. a)-capacitive probe gauges b)-gravitational gauges deformation ) gauges d)-digital gauges
Answers: 1
You know the right answer?
WHAT IS MEANT BY BJT AND FUNCTION OF BJT...
Questions
Mathematics, 07.12.2020 14:00
Mathematics, 07.12.2020 14:00
Social Studies, 07.12.2020 14:00
Chemistry, 07.12.2020 14:00
Computers and Technology, 07.12.2020 14:00
Mathematics, 07.12.2020 14:00
Social Studies, 07.12.2020 14:00
Chemistry, 07.12.2020 14:00
Mathematics, 07.12.2020 14:00
Mathematics, 07.12.2020 14:00
Mathematics, 07.12.2020 14:00
