Engineering, 21.05.2021 16:50 kaziyahf2006
Which of the following enables manufacturers to provide products made in less time and with less money, less pollution, less energy, and less use of natural resources?
Answers: 1
Engineering, 03.07.2019 15:10
Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.
Answers: 1
Engineering, 04.07.2019 18:10
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
Engineering, 04.07.2019 18:10
An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature
Answers: 2
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
Which of the following enables manufacturers to provide products made in less time and with less mon...
History, 31.01.2021 14:00
Mathematics, 31.01.2021 14:00
Mathematics, 31.01.2021 14:00
History, 31.01.2021 14:00
Mathematics, 31.01.2021 14:00
Mathematics, 31.01.2021 14:00
Mathematics, 31.01.2021 14:00
English, 31.01.2021 14:00
Mathematics, 31.01.2021 14:00
Physics, 31.01.2021 14:00
Computers and Technology, 31.01.2021 14:00
History, 31.01.2021 14:00
Social Studies, 31.01.2021 14:00