Engineering, 24.05.2021 20:50 dinadenoirefan

Consider the effect of the catcher mechanism on the final (maximum) height. The catcher mechanism is not taken into account in our calculations. Based on this, do you think the calculated velocity of the pendulum plus ball immediately after colision, higher or lower than the true velocity of the pendulum plus ball immediately after collision? Is the calculated initial velocity of the ball, higher or lower than the true velocity of the ball? Based on this, do we expect the speed of the ball calculated from the photogate time to be larger or smaller than the speed obtained from the ballistic pendulum calculation? Does this agree with the experimental data? If the effect of the massless rod approximation is to lower the ballistic pendulum result by about 5% compared to the true value, estimate the effect of the catcher mechanism fassuming this is the other main source of error)

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 16:10

An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)

Answers: 2

Answer

Engineering, 04.07.2019 18:10

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Determine the damped natural frequencies and the steady state response of a decoupled damped forced two degrees of freedom system. 10ä1 + 2q1 20q1 10 cos t; 10q2 +4q2 + 40q2 10 cos t

Answers: 3

Answer

Engineering, 04.07.2019 18:20

Air flows over a heated plate àt a velocity of 50m/s. the local skin factor coefficient at a point on a plate is 0.004. estimate the local heat transfer coefficient at this point.the following property data for air are given: density = 0.88kg/m3 , viscosity 2.286 x 10 ^-5 kgm/s , k = 0.035w/mk ,cp = 1.001kj/kgk. use colburn reynolds analogy.

Answers: 1

Answer

You know the right answer?

Consider the effect of the catcher mechanism on the final (maximum) height. The catcher mechanism is...

Questions