Engineering, 25.05.2021 18:40 chimwim8347
The open-circuit and shot-circuit tests are performed on a 240-kVA, 4800/240-V, 60-Hz transformer. The obtained data are as follows. Voltage, V Current, A Power, W Open-circuit test 240 9.7 1440 Short-circuit test 188.6 50.2 2625 1) Determine the parameters of the approximate equivalent circuit as referred to the high-voltage side. Draw the circuit showing the pertinent parameters. 2) Find the efficiency when the transformer is operating at 97% of its rated load, 0.78 power factor lagging and rated terminal voltage. 3) Calculate the load kVA at maximum efficiency and the transformer efficiency for this load kVA at 0.78 power factor lagging.
Answers: 2
Another question on Engineering
Engineering, 03.07.2019 15:10
If you were designing a bumper for a car, would you prefer it to exhibit elastic or plastic deformation? why? consider the functions of a bumper in both a minor "fender-bender" and a major collision.
Answers: 1
Engineering, 04.07.2019 19:10
In general, how do thermosetting plastics compare to thermoplastics in mechanical and physical properties?
Answers: 3
Engineering, 04.07.2019 19:20
Apiping systems consists of 6 m of 6-std type k and 12 m of 4-std type k, both drawn copper tubing. the system conveys ethylene glycol at a rate of 0.013 m3/s. the pressure drop across the system is to be calculated. there are two 90° elbows in the 6-in pipe, a reduction from the 6-in pipe to the 4-in pipe and four 90° elbows in the 4-in pipe. all fittings are soldered (same as flanged) and regular. the inlet and outlet of the system are at the same height.
Answers: 1
Engineering, 06.07.2019 02:30
Plot schematically the tensile stress versus strain curves for a typical thermoplastic material at a temperature below its glass transition temperature (tg and at a temperature above its tg, respectively. do the same for a typical thermosetting material. list in a table any differences or similarities between the two materials at t> tg and t < tg, respectively, and relate them to the structures of the two types of polymers
Answers: 3
You know the right answer?
The open-circuit and shot-circuit tests are performed on a 240-kVA, 4800/240-V, 60-Hz transformer. T...
Questions
Computers and Technology, 12.12.2019 03:31
Mathematics, 12.12.2019 03:31
