Engineering, 26.05.2021 14:00 Mikec123

This question is designed to check your understanding of code for LCD display shared earlier with students.
Here is the Pseudocode for what needs to be displayed on the screen.
Display your full name.
Delay of 0.5 seconds
Display your Registration number.
Delay of 1 seconds
Display “MBSD Midterm 21”
Delay of 1.5 seconds
Display all characters of your First name one by one with a delay equal to the ASCII value of the
character display. Also display the decimal value of the ASCII character along with the character
itself. The format to display the information is given below.
Here is an example.
Display “M: 77”
Delay (77 ms)
Display “A: 65”
Delay (65 ms)
Display “L: 76”
Delay (76 ms)
Display “I: 73”
Delay (73 ms)
Display “K: 75”
Delay (75 ms)

Answers: 2

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan

Answers: 3

Answer

Engineering, 04.07.2019 19:10

What is the chief metrological difference between measuring with a microscope and with an electronic comparator? a. the microscope is limited to small workpieces.a. the microscope is limited to small workpieces. c. the comparator can only examine one point on the workpiece. d. the microscope carries its own standard.

Answers: 1

Answer

Engineering, 04.07.2019 19:10

The air in an automobile tire with a volume of 0.015 m3 is at 32°c and 140 kpa gage. determine the amount of air that must be added to raise the pressure to the recommended value of 206 kpa gage. assume the atmospheric pressure to be 128 kpa and the temperature and the volume to remain constant.[r-0.287 kj/kgk]

Answers: 3

Answer

You know the right answer?

This question is designed to check your understanding of code for LCD display shared earlier with s...

Questions