Engineering, 28.05.2021 22:10 hailiemanuel9362

You are the Leadership in Energy & Environmental Design (LEED) certifier in your area. You must analyze the construction of three different nearby buildings. You may choose whichever buildings you would like, but try to choose buildings with different purposes (libraries, offices, schools, churches). You might want to contact the builder or architect for the building if you are able to help find scores for your LEED categories. Choose five to seven different categories for your ratings, and use the exact same ratings for each building. This means that if you choose water efficiency, you must rate each of the three buildings on water efficiency. Calculate the credits for each of the categories, and provide a total score for each building. Suggest changes for each of the buildings to help them increase their LEED ratings. You will present this information in a script for a 3- to 5-minute oral presentation to discuss your findings. You must incorporate pictures or drawings of the buildings to support your presentation.

Answers: 2

Show answers

Another question on Engineering

Engineering, 03.07.2019 14:10

When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point

Answers: 3

Answer

Engineering, 04.07.2019 16:10

An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)

Answers: 2

Answer

Engineering, 04.07.2019 18:10

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

Answer

Engineering, 04.07.2019 18:20

Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency

Answers: 1

Answer

You know the right answer?

You are the Leadership in Energy & Environmental Design (LEED) certifier in your area. You must...

Questions