Engineering, 31.05.2021 16:50 Adreanna1018
5) Explain how to use other sources of information to support the data (such as electronic component pin configuration specifications, reference charts, standards, bend allowances required for material thickness, electrical conditions required for specific welding rods, mixing ratios for bonding and finishing materials, metal specifications and inspection requirements, health and safety documentation)
Answers: 2
Another question on Engineering
Engineering, 04.07.2019 16:10
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
Engineering, 04.07.2019 18:10
An air conditioning system consist of a 5 cm diameter pipe, operating at a pressure of 200 kpa. the air initially enters the pipe at 15°c with a velocity of 20 m/s and relative humidity of 80%. if the heat supply throughout the process is 960 w, determine the relative humidity and the temperature at the outlet
Answers: 3
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
You know the right answer?
5) Explain how to use other sources of information to support the data (such as electronic component...
Questions
Mathematics, 20.01.2021 04:10
English, 20.01.2021 04:10
Spanish, 20.01.2021 04:20
Mathematics, 20.01.2021 04:20
Chemistry, 20.01.2021 04:20
Mathematics, 20.01.2021 04:20
Mathematics, 20.01.2021 04:20
Mathematics, 20.01.2021 04:20
Mathematics, 20.01.2021 04:20
English, 20.01.2021 04:20
Mathematics, 20.01.2021 04:20
