subject
Engineering, 02.06.2021 22:00 nadiarose6366

A constant pressure container is filled with 1 kg of stainless steel and 0.5 kg of PVC (polyvinyl chloride) both at 20oC and 0.25kg of hot air at 500 K, 100 kPa. The container is now left alone with no external heat transfer. Find the final temperature and the process work.

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:20
Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis
Answers: 1
question
Engineering, 04.07.2019 19:10
Estimate the change in specific internal energy au and specific enthalpy h from inlet to outlet for ethylene glycol (a liquid) flowing through each of the following devices: (a) a heat exchanger where the glycol temperature increases from 20 °c to 80 °c; (b) a pump operating at about 25 °c and increasing the glycol pressure from 100 kpa to 8 mpa.
Answers: 2
question
Engineering, 04.07.2019 19:20
Acompressor compresses a gas, a pump compresses a liquid. for a given pressure ratio, why does it take more work to compress a gas in a compressor than a liquid in a pump? a)- for a given pressure ratio the average specific volume for a gas is much higher than the average specific volume for a liquid. b)- there is no difference. the only difference is the amount of heat generated (not work) c)- for a given pressure ratio the average volurge for a gas is much higher than the average volume for a liquid. d)-there is no difference
Answers: 3
question
Engineering, 06.07.2019 02:30
Plot schematically the tensile stress versus strain curves for a typical thermoplastic material at a temperature below its glass transition temperature (tg and at a temperature above its tg, respectively. do the same for a typical thermosetting material. list in a table any differences or similarities between the two materials at t> tg and t < tg, respectively, and relate them to the structures of the two types of polymers
Answers: 3
You know the right answer?
A constant pressure container is filled with 1 kg of stainless steel and 0.5 kg of PVC (polyvinyl ch...
Questions
question
Mathematics, 01.03.2021 05:10
question
Business, 01.03.2021 05:10
question
Mathematics, 01.03.2021 05:10
question
Mathematics, 01.03.2021 05:10
question
Spanish, 01.03.2021 05:10
Questions on the website: 13722362