subject
Engineering, 03.06.2021 08:30 allakhalilpea0zc

Question 3 A fast spinning tennis ball in the air of density 1.23 kg/m3 will result in its deviation from the vertical trajectory as a result of lift force. Table Q3 shows the average speed and tennis ball spin rate from top male tennis player. In a tennis tournament, a tennis ball of 65.4 mm diameter is used and being hit by one of your favourite tennis player.
(a) By potential flow theory, determine the stagnation points location on the tennis ball and sketch the flow field around the tennis ball.
(b) Determine the lift force experience by the tennis ball as in Q3(a).
(c) In a prestigious tennis tournament, a good strategy need to be taken by your favorite tennis player in order to give a difficult prediction of the tennis ball
trajectory to his opponent. Using your knowledge in potential flow theory, explain
how the strategy will influent the tennis ball trajectory.
(d) In another situation, a negative lift can be experienced by the tennis ball. Explain
briefly how this effect is possible with the stagnation points' location.
(e) In a wind tunnel experiment for drag and lift measurement on the tennis ball,
pressure tapping on the tennis ball surface will give the pressure distribution data. Derive the pressure distribution expression so that the experimental and theoretical data can be compared.

Table Q3 - Average speed and spin rate for some male tennis players (extracted from Alam and Subic, 2008)


Question 3

A fast spinning tennis ball in the air of density 1.23 kg/m3 will result in its deviat

ansver
Answers: 1

Another question on Engineering

question
Engineering, 03.07.2019 15:10
Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.
Answers: 1
question
Engineering, 03.07.2019 19:30
When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line
Answers: 3
question
Engineering, 04.07.2019 18:10
Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.
Answers: 2
question
Engineering, 04.07.2019 18:20
The characteristic roots of a dynamic system are: 1.7920 1.8160 i, -1.7920 1.8160 i, -0.4160 what is the order of this system? what are the settling time and damping ratio of the system?
Answers: 3
You know the right answer?
Question 3 A fast spinning tennis ball in the air of density 1.23 kg/m3 will result in its deviatio...
Questions
question
Mathematics, 25.09.2020 14:01
question
Computers and Technology, 25.09.2020 14:01
question
Mathematics, 25.09.2020 14:01
question
Mathematics, 25.09.2020 14:01
question
Mathematics, 25.09.2020 14:01
Questions on the website: 13722359