Engineering, 03.06.2021 18:40 sukiyoshi10

DOUBLE INTEGRATION METHOD A consultancy firm is designing a canopy as shown below in Q. 1. a, to provide shelter for the entrance of a building. The roof consists of a plain lightweight concrete cast over a steel decking and is placed on Universal Beams (UB). The roof is subjected to a live load caused by drifting snowed which is assumed to be trapezoidal. The idealized beam considering the lightweight concrete, steel decking and snow are shown in Q. 2. b. The initial beam selected has a moment of inertia, =2841 4, and a modulus of elasticity, =200 . Design codes specify the maximum deflection should not exceed Δ=/ where is the span of the beam in mm. Determine whether the maximum deflection of the beam is less than the permissible deflection. If it is more than the permissible deflection recommend a minimum moment of inertia in cm4 that will meet the design codes specifications.

Answers: 3

Show answers

Another question on Engineering

Engineering, 04.07.2019 18:10

Asingle-geared blanking press has a stroke of 200 mm and a rated capacity of 320 kn. a cam driven ram is assumed to be capable of delivering the full press load at constant force during the last 15 percent of a constant-velocity stroke. the camshaft has an average speed of 90 rev/min and is geared to the flywheel shaft at a 6: 1 ratio. the total work done is to include an allowance of 16 percent for friction a) estimate the maximum energy fluctuation b) find the rim weight for an effective diameter of 1.2 m and a coefficient of speed fluctuation of 0.10

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.

Answers: 1

Answer

Engineering, 04.07.2019 18:10

True or false (explain) (110)[111] is a slip system in bcc metals . the {111} family in fcc contains 8 planes. resolved shear stress (rss) in single crystals is just related to the applied stress. critical resolved shear stress (crss) in single crystal metals is direct proportional to the number of defects in the structure

Answers: 2

Answer

You know the right answer?

DOUBLE INTEGRATION METHOD A consultancy firm is designing a canopy as shown below in Q. 1. a, to pr...

Questions