Engineering, 16.06.2021 05:10 naenae2cold12021
trình bày hiểu biết của bạn về các phương pháp gia công cắt gọt kim loại. cho ví dụ cụ thể về ứng dụng công nghệ gia công cắt gọt trong thực tế sản xuất
Answers: 1
Engineering, 04.07.2019 18:10
An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature
Answers: 2
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
Engineering, 04.07.2019 18:20
Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent
Answers: 2
Engineering, 04.07.2019 19:10
What is the main objective of using reheat rankine cycle?
Answers: 3
trình bày hiểu biết của bạn về các phương pháp gia công cắt gọt kim loại. cho ví dụ cụ thể về ứng dụ...
Mathematics, 12.03.2021 18:30
Health, 12.03.2021 18:30
Mathematics, 12.03.2021 18:30
Advanced Placement (AP), 12.03.2021 18:30
Mathematics, 12.03.2021 18:30
Mathematics, 12.03.2021 18:30
Law, 12.03.2021 18:30