Engineering, 24.06.2021 04:50 smarty5187
Conveyor belt drive, with active and passive pulley diameters of 200 and 600 mm. Shaft distance is 540mm. Determine the length of wire so that the shaft distance is the least deviation and the gear ratio of the transmission
Answers: 3
Another question on Engineering
Engineering, 03.07.2019 14:10
If the thermal strain developed in polyimide film during deposition is given as 0.0044. assume room temperature is kept at 17.3 c, and thermal coefficient of expansion for the film and the substrate are 54 x 10^-6c^-1 and 3.3 x 10^-6c^-1respectively. calculate the deposition temperature.
Answers: 3
Engineering, 04.07.2019 18:10
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
Engineering, 04.07.2019 18:10
Afluid flows with a velocity field given by v=(x/t)i.. determine the local and convective accelerations when x=3 and t=1.
Answers: 2
Engineering, 04.07.2019 18:10
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
You know the right answer?
Conveyor belt drive, with active and passive pulley diameters of 200 and 600 mm. Shaft distance is 5...
Questions
Mathematics, 03.05.2021 20:40
Spanish, 03.05.2021 20:40
Physics, 03.05.2021 20:40
Mathematics, 03.05.2021 20:40
Mathematics, 03.05.2021 20:40
History, 03.05.2021 20:40
Biology, 03.05.2021 20:40
Physics, 03.05.2021 20:40
