Engineering, 26.06.2021 19:10 sswd
The effective diameters of two pulleys of a belt drive are 300 mm and 900 mm respectively. The large pulley rotates at 120 r/min and is then accelerated uniformly to 660 r/min during 50 revolutions. Calculate: The final linear velocity of the belt.
Answers: 3
Another question on Engineering
Engineering, 03.07.2019 14:10
Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned
Answers: 2
Engineering, 04.07.2019 18:10
Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.
Answers: 1
Engineering, 04.07.2019 18:10
Which of the following ziegler nichols tuning methods the response of the controller to a step input should exhibit an s-shaped curve? a)-open loop mode b)-closed loop mode c)-both modes (open & closed) d)-none of the modes (open & closed)
Answers: 3
Engineering, 04.07.2019 18:10
Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan
Answers: 3
You know the right answer?
The effective diameters of two pulleys of a belt drive are 300 mm and 900 mm respectively. The large...
Questions
English, 09.11.2019 07:31
History, 09.11.2019 07:31
Mathematics, 09.11.2019 07:31
Chemistry, 09.11.2019 07:31
Mathematics, 09.11.2019 07:31
Mathematics, 09.11.2019 07:31
Mathematics, 09.11.2019 07:31
Geography, 09.11.2019 07:31
Chemistry, 09.11.2019 07:31
Mathematics, 09.11.2019 07:31
