subject
Engineering, 27.06.2021 09:20 grace9874

I) A double-column enlarged-ends manometer is used to measure a small pressure difference between the two points of a system conveying air under pressure, the diameter
of U-tube being 1/8 of the diameter of the enlarged ends. The heavy liquid used is water
and the lighter liquid in both limbs is oil of relative density 0.79. Assuming the surfaces of
the lighter liquid to remain in the enlarged ends, determine the difference in pressure in
metres of water for a manometer displacement of 70 mm.
(4 marks)
What would be the manometer reading if carbon tetrachloride (of relative density 1.56)
were used in place of water, the pressure conditions remaining the same? (3 marks)
dr
0
Oil
dx
Area, A
b
70
Area, a
DO
Water

ansver
Answers: 3

Another question on Engineering

question
Engineering, 04.07.2019 18:20
Athin walled concentric tube exchanger is used to cool engine oil from 160°c to 60°c with water that is available at 25°c acting as a coolant. the oil and water flow rates are each at 2 kg/s, and the diameter of the inner tube is 0.5 m and the corresponding value of the overall heat transfer coefficient is 250 w/m2. oc. how long must the heat exchanger be to accomplish the desired cooling? cpwater=4.187 kj/kg-candcpengine el=2.035 kj/kg·°c, oil . 120]
Answers: 1
question
Engineering, 04.07.2019 18:20
Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?
Answers: 2
question
Engineering, 06.07.2019 03:30
Abrayton cycle operates with a regenerator on the air-standard with properties evaluated at 400 k. the tem- perature of the air entering the compressor is 350k while the temperature of the air exiting the compressor is 600 k. the temperature of the air entering the turbine is 1600 k. the overall cycle produced 600 kj/kg of net work out. assuming a regenerator effectiveness of 0.8, what is the temperature of the air before heat addition (combustion)? draw this process on a t - s diagram
Answers: 3
question
Engineering, 06.07.2019 04:30
Briefly discuss how plastic deformation occurs in crystalline materials discuss the five most important methods of strengthening of metals and alloys.
Answers: 2
You know the right answer?
I) A double-column enlarged-ends manometer is used to measure a small pressure difference between t...
Questions
question
English, 05.02.2021 01:40
question
Mathematics, 05.02.2021 01:40
question
English, 05.02.2021 01:40
question
Mathematics, 05.02.2021 01:40
question
History, 05.02.2021 01:40
question
Social Studies, 05.02.2021 01:40
question
English, 05.02.2021 01:40
question
Social Studies, 05.02.2021 01:40
Questions on the website: 13722363