Engineering, 27.06.2021 09:20 VETORRES
I) A pontoon is 65m long, 18m wide and and 10m deep. It has a draft of 6.5m when floating
in an upright condition. The centre of gravity of the pontoon is on the axis of symmetry,
0.75m above the water surface.
Compute:
a) The initial metacentric height
(3 marks)
b) The righting moment in fresh water when the angle of heel, is 12º. (3 marks)
Answers: 2
Another question on Engineering
Engineering, 04.07.2019 16:10
The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.
Answers: 1
Engineering, 04.07.2019 18:10
Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.
Answers: 1
Engineering, 04.07.2019 18:10
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
Engineering, 04.07.2019 18:20
Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis
Answers: 1
You know the right answer?
I) A pontoon is 65m long, 18m wide and and 10m deep. It has a draft of 6.5m when floating
in an upr...
Questions
Mathematics, 18.03.2021 21:00
Social Studies, 18.03.2021 21:00
Mathematics, 18.03.2021 21:00
Mathematics, 18.03.2021 21:00
History, 18.03.2021 21:00
Mathematics, 18.03.2021 21:00
Mathematics, 18.03.2021 21:00
Mathematics, 18.03.2021 21:00
Physics, 18.03.2021 21:00
History, 18.03.2021 21:00
