subject
Engineering, 06.07.2021 22:10 xojade

The compression ratio of an ideal air standard Otto cycle is 9.5. Before the isentropic compression process, the air is at 100 kPa and 35°C. The temperature at the end of isentropic
expansion is 800 K. Assume that air is an ideal gas with constant specific heats, calculate each of
the following, given that Cr=0.718 kJ/kgK, Cp=1.005 kl/kg K and gamma=1.4
1) The temperature after isentropic compression
a) 650 K b) 758 K c) 473K d) 512 K
2) The highest temperature in the cycle
a) 1969 K b) 2320 K c) 1250 K d) 941 K
3) The amount of heat added to the cycle in kJ/kg
a) 1360.5 b) 869.5 c) 1220.2 d) 678.4
4) The amount of heat rejected from the cycle in kJ/kg
a) 223.5 b) 495.7 c) 353.2 d) 687.8
5) The net work output from the cycle in kl/kg
a) 396.5 b) 516.2 c) 1135.2 d) 819.2
6) The cycle efficiency is
a) 59.4% b) 69.6% c) 36.2% d) 42.5%

ansver
Answers: 2

Another question on Engineering

question
Engineering, 03.07.2019 14:10
Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.
Answers: 2
question
Engineering, 04.07.2019 18:10
Water at the rate of 1 kg/s is forced through a tube with a 2.5 cm inner diameter. the inlet water temperature is 15°c, and the outlet water temperature is 50°c. the tube wall temperature is 14°c higher than the local water temperature all along the length of the tube. what is the length of the tube?
Answers: 3
question
Engineering, 04.07.2019 19:10
The sum of the normal stresses does not change as the stress state rotates through an angle. a)-trune b)- false
Answers: 2
question
Engineering, 06.07.2019 03:20
What is the maximum height from which a mass of 30 kg can fall on to a flange on the lower end of a vertical rod of length 1.0 m and diameter 20 mm, the upper end being rigidly fixed, if the stress in the rod is not to exceed 80 mpa? the tensile modulus of the rod is 200 gpa.
Answers: 3
You know the right answer?
The compression ratio of an ideal air standard Otto cycle is 9.5. Before the isentropic compressi...
Questions
question
Geography, 13.11.2019 03:31
question
Mathematics, 13.11.2019 03:31
Questions on the website: 13722367